from Monday to Friday (except holidays) for orders of more than 30€ to mainland Spain/Portugal.
Shop: | 3D Printers |
Category: | Adhesion |
Reference: | HE3DSP80ML |
3DLAC Stick is a 3D printing adhesive that serves to prevent warping and to firmly fix the first printing layer throughout the entire process.
This new format has an applicator that allows you to control and distribute the product on the surface in an easy and uniform way , in addition, its formula has been designed to remove the piece easily once the process is finished.
This product has a wide range of print surface and filament compatibility.
With the 3DLac Stick format you will achieve considerable savings in adhesive, by applying only in the areas where you are going to print, without wasting material, in addition, you avoid the adhesive falling on other sensitive surfaces of the 3D printer.
The 3DLac Stick must be shaken well before use . It should always be applied on a clean and dry surface, gently pressing the applicator against the printing surface for a few seconds until the product begins to flow. The sides of the bottle should not be pressed too firmly, as this will cause the applicator to fall and product to spill. The product must be spread in a thin, even layer and allowed to dry before starting the 3D printing process.
The 3DLack Stick should be stored in a cool, dry place, out of direct sunlight . The cap must be replaced on the bottle after each use, otherwise the applicator will dry out.
The build platform must be allowed to cool (at least 30°C) before removing the part from the build bed . The special formula of 3DLac Stick makes it easy to remove the part, but it must be done with great care . If removal is problematic, the base piece can be placed in a refrigerator and the piece will release with just a light touch.